Cook Laboratory Exhaust Uživatelský manuál

Rigging and Installation Instructions for Single Piece and Multiple Piece Energy Recovery Plenums Due to the custom design and build natu

Figure 3.3 Bolting Method Inside Demount – Angles Figure 3.4 Bolting Method Inside Demount – Flat Plates

Figure 3.5 Bolting Method Inside Demount – Four Corner Connection

4.1 Water Shedding Components If the equipment is designed as an outdoor unit it will be supplied with a water shedding roof installed over the pan

Figure 7 Typical Outdoor Units, Water Shed Panels Center Pitched Roof, Water Shed Panels Perpendicular to Pitch of Roof

5.0 Finish Work for the Installation Once the equipment has been set and completely bolted together, the following finish work must be done to comp

6.0 Installation of Extended Exhaust Porch The final step in assembly of the equipment is the installation of the extended exhaust. 1. Caulk

7.0 Recommended Tools The following are recommended tools that the contractor should have on hand for the rigging. Provisions of these tools are at

1.0 Pre-Lift Considerations Curbs may be structural steel, formed concrete or formed metal. A Loren Cook supplied formed metal curb will be shipp

2.0: Receiving of the Equipment Most equipment delivered is shipped FOB Factory. Once the equipment is loaded on the trailer, it ownership and resp

2.1.2 Long-Term Storage Long-term storage is considered to be any period longer than six (6) months from date of shipment. If long-term storage i

Adjustable pulley forevery two lifting eyes.Adjustable clampfor adjusting widthof spreader.Figure 1 is an example of a rigging and spreader bar unit.

3.1 Rigging a Single Piece Unit Note: Use all of the lifting points provided on the equipment. Loren Cook will not be responsible for damages incu

3.2 Rigging a Multiple Section Unit Note: Use all of the lifting points provided on the equipment. Loren Cook will not be responsible for damages

4.0 Assembly of the Sections Apply the 1”x3/8” gasket material to the frame as shown in figure 3. Apply this gasket to only one section of the two

Figure 3.2